Problem transferring routes to Quest 2

[skellum]

I am having a couple of problems with my Quest 2

1) I am travelling to France in a couple of weeks and thought it would be a good idea to transfer the routes I had prepared in mapsource to the Quest so I could run the route simulation program - on all 4 routes transferred the unit runs through about a minute of the route and then asks if I wish to re start the route? If I restart then it starts the whole route again and brings up the same message.

2) I also transferred an old route I had in Mapsource to the Quest 2 however as soon as I tried to open this route it told me the maps did not match "do you want to recalculate the route" - I think originally they were made in Mapsource on V6 but have now updated through to V8 and still looked at the route in Mapsource before transferring.

I had updated the unit Software to the latest revision 12/7/06 and the latest webupdater (June)

Any advice would be appreciated - I am quite dissapointed that since changing to the Quest 2 from my original Quest I seem to have nothing but problems - with slow redraw's, slow calculations etc - the new unit seems unwieldy (software wise) compared to the original.

Cheers

[Skippy]

[skellum]

[Skippy]

[bigbob]

Hi Skellum
Have just returned from France and my Quest 2 was a bit quirky downloading Maps as well before I went so what I did was download waypoints to Q2 and let the unit calculate the routes (see other posts) this worked fine.

[skellum]

We see you’re using an ad-blocker. We’re fine with that and won’t stop you visiting the site.
Have you considered making a donation towards website running costs?.
Or you could disable your ad-blocker for this site. We think you’ll find our adverts are not overbearing!