Garmin i3 diagnostic pages

[paulburrows]

Just noticed this after upgrading to firmware version 3.20. Don't know if it works with other versions.

Switch off, hold down the left arrow, then switch on the unit.

It enters a diagnostic type mode with several screens accessible by using the left arrow, scroll wheel button and power button.

Lots of interesting information to look at. Don't think you can change anything though.

[timber]

[paulburrows]

Thanks. I was TRYING to do a factory reset, but forgot to hold down the middle button.

By just holding the left button when switching on, it goes into a mode where you can see signal information, a graphic satellite map, the temperature(!), various logs, test patterns and test sounds and loads of other stuff.

We see you’re using an ad-blocker. We’re fine with that and won’t stop you visiting the site.
Have you considered making a donation towards website running costs?.
Or you could disable your ad-blocker for this site. We think you’ll find our adverts are not overbearing!