TT3 on hx4700

[just_a_bloke]

Hi folks can anyone help me out with this...

I have the TT3 wired solution using a PackardBell 3025

Yesterday I bought a hx4700 and installed TT3 on it.

The installation process noted that TT3 was intended for a previous version of Windows but appeared to install

This installation has (at least ) 2 issues

(1) No voices
(2) Can not connect to the GPS receiver

Do I need to get a new cable to connect the GPS to the hx4700 ( I used the one supplied for connection to the PackBell) ?

[mikealder]

OK - welcome, check the volume level in the TT3 settings page and make sure you have selected a voice (Jane is the normal one), as for the GPS unit it must be compatable with the IPAQ, so a new cable is probably required, I would not recomend using one for a different unit as it could damage either the GPS or worse still the IPAq - Mike

[just_a_bloke]

Thanks for your advice , I'll re check the GPS reciever against the PackardBell to test if it still works - then I'll get cable for the iPaq ( or a new GPS module !

We see you’re using an ad-blocker. We’re fine with that and won’t stop you visiting the site.
Have you considered making a donation towards website running costs?.
Or you could disable your ad-blocker for this site. We think you’ll find our adverts are not overbearing!