Brodit mount - advice on fixing together please

MJ_Devon · Occasional Visitor Joined: Jul 27, 2005 Posts: 2

Would be grateful if any existing Brodit owners can give me advice please.

Just received a Brodit angle mount for a Honda civic, and a passive holder for a dell axim (thanks GPSforless- excellent service).

The car mount has a blank ABS plastic plate which the passive mount should fix to - no holes or adhesive.

The pda holder has 4 holes drilled in the back and is supplied with screws.

What is the best way to fix these together ?
Drill holes in the blank ABS plate or buy an adhesive mount to sandwich between the two.
Am a bit reluctant to drill unless necessary.

I'm surprised the instructions dont clarify this as the 2 are obviously designed to be used together.

Many thanks.

Oldie · Posted: Wed Jul 27, 2005 11:00 am Post subject:

I usually attach the mount to the proclip using double sided tape and then pre-drill holes for the four screws. This makes it much easier to assemble.

There should have been instructions in the kit, but have a look on the Brodit website www.brodit.com and you should find instructions for your kit.

Richard
_________________
Various TomToms, Garmin eTrex Legend, GPSMAP 60CSx, Oregon 550t, Forerunner 405

Privateer · Posted: Wed Jul 27, 2005 1:13 pm Post subject:

Hi MJ_Devon,

I use the Brodit Move Clip system (213005), which allows you to swap holders. You can also remove the holder and leave just the ProClip in place, for security when you leave your car.

Regards,
_________________
Robert.
iPhone 6s Plus, iOS 14.0.1: iOS CamerAlert v2.0.7
TomTom GO Mobile iOS 2.3.1; TomTom (UK & ROI and Europe) iOS apps v1.29
Garmin Camper 770 LMT-D

MJ_Devon · Occasional Visitor Joined: Jul 27, 2005 Posts: 2

Sorted with a bit of drilling !
Thanks for the replies.

Oldie · Posted: Thu Jul 28, 2005 7:45 am Post subject:

	PocketGPS
	Web