iPaq 6340 + ClipOn + TTN3

Consultant · Posted: Thu Jun 30, 2005 8:26 am Post subject: iPaq 6340 + ClipOn + TTN3

Hi All,

Just done a fresh re-install of TTyN3 (3.07) on my HP iPaq 6340. For the last year or so (since TTN3 was released) I was using the setup with TTN set to "Emtac Wireless GPS" as per a post a long time ago on here.

Long story short, I can't get TTN3 to talk to the GPS. Very annoying, I've tried NMEA settings as suggested in other posts on the subject with no luck. I can connect the iPaq and GPS Unit with a standard BT connection via the Connection Manager, but cannot get TT to get a connection. I use BT Com Port 4. Switching between XT modes doesn't seen to help either

Any suggestions?

Cheers

T.

lbendlin · Posted: Thu Jun 30, 2005 5:44 pm Post subject:

Standard NMEA 38400

Bluetooth Serial Port COM7:
_________________
Lutz

Report Map Errors here:
TomTom/TeleAtlas NAVTEQ

Consultant · Posted: Thu Jun 30, 2005 6:08 pm Post subject:

Hiya...

Was just about to reply... took the usual couple of hours fiddling, but I got there in the end. Sorted it about 10 mins ago. Still using the "Emtac Wireless GPS" setting as I always have. I'm sure this won't be an issue though. Used COM7 as you stated

Thanks for replying though....

Kind Regards

T.

	PocketGPS
	Web