Error message when I try to down load Database

xxybird · Occasional Visitor Joined: Jun 19, 2009 Posts: 4

When I try to down load the Speed Camera Database on to my Garmin Street Pilot c510, I get an error message that says disk is full! I take it that this is refering to the memory card and not the on board memory? IF so, how big a memory card would I need? 2/4/8 gb? Im new to this so any help would be appreciated.

PaulB2005 · Posted: Fri Jun 19, 2009 5:06 pm Post subject:

Hi and welcome to the Forums.

Do you have a memory card installed?

What drive did you pick when POILoader asked you?

The PGPSW Database is very small and will easily fit onto a memory card of almost any size. I'm suprised it doesn't fit on your C510.

Have you added anything else to the C510 in the past?

xxybird · Occasional Visitor Joined: Jun 19, 2009 Posts: 4

Hi;

Yes I have tried it with a 32mb card, and a 2gb card with no luck. My PC shows the card as GARMIN K drive. The data base starts to down load to my street pilot then I keep getting the error message.

PaulB2005 · Posted: Fri Jun 19, 2009 5:19 pm Post subject:

The cards are formated and blank?

How much room do you have left on the main unit memory?

Have you tried sending it to the main unit memory?

xxybird · Occasional Visitor Joined: Jun 19, 2009 Posts: 4

Hi ,

Think I just sorted it, while I was waiting for your reply I managed to down load straight to my 32mb card through my PC card reader. I assume my garmin will now read the new data base from the card?

PaulB2005 · Posted: Fri Jun 19, 2009 5:41 pm Post subject:

Should do.

xxybird · Occasional Visitor Joined: Jun 19, 2009 Posts: 4

Many thanks for your help.

	PocketGPS
	Web