How to setup to avoid areas

Macs · Posted: Fri Jun 17, 2005 8:20 am Post subject: How to setup to avoid areas

Hlo everyone, I wonder if anyone canhelp?
I intend to go on a journey and when I put in the start and finish points my Navman insists on sending me via the A1 for the whole journey and I dont want to go that way. I want to use the M1 instead. Is it possible to set this up to avoid all or some of the A1?

Daytona · Regular Visitor Joined: Apr 03, 2005 Posts: 60

Rather than set the A1 to avoid as you may wish to use it in the future, scroll to a point on the M1 (say the junction to enter by), zoom rght in and tap the road with the stylus. This gives you the option to add that point to the journey. You can do this for a number of points on the way.
Don't forget, there is a journey planner screen where you may have to arrange the order of these points so they run in order so the trip makes sense.

Macs · Posted: Fri Jun 17, 2005 9:01 am Post subject:

Thanks a lot, I'll try it

Tim Buxton · Posted: Fri Jun 17, 2005 10:33 am Post subject:

Just to answer the original question, P. 18 of your manual describes how to set up "Avoid" areas and P. 16 shows how to use the Trip Planner.
_________________
Tim

Macs · Posted: Fri Jun 17, 2005 10:52 am Post subject:

To be hoest I didnt know if there was a way in each journey to set it up E.g #avoid A1

Tim Buxton · Posted: Fri Jun 17, 2005 11:10 am Post subject:

No, unfortunately not.
_________________
Tim

Macs · Posted: Fri Jun 17, 2005 11:39 am Post subject:

Ok thanks

	PocketGPS
	Web