Search found 37 matches

There seems to be various posts cropping up with people having issues with our SiRF III based receivers and using them whilst out walking or hiking.

If you are one of these people then you should s ...

Okay, let's try and de-mystify some confusion here:

Buad rate - it shouldn't matter what baud rate you set your GPS to (providing of course that your software is set to the same) as it is still sen ...

Dear Ranger,

Destinator is able to use SMS in order to send location info derived from the GPS attached to the smart phone - this is the issue though you need to have a PDA with built in phone or a ...

Hi Ulf,
Depending on where you purchased your receiver from will depend on which firmware version your GR213 has. The latest version is 3.1.1.
The firmware is upgradable using the USB cable but we d ...

Hi NickG

Wow! Your post makes for very interesting reading!

May we be so bold as to make a suggestion:

Instead of procrastinating why don't you share with everybody else your obviously vast ...

Hi,
Yes, the solution to the activesync problem with the XDA is to cut pin6 in the CR100 connector. We have tested this with a number of units in the field and there have been no problems with either ...

Hi TTrevor,
We can do you a cable to charge the GR236 from an RJ11, which I assume is on a PDA mount.
If you give someone in the shop a call on 0870 321 6929 and let them know which mount you have w ...

Hi Ulf,
I've read your post differently from NC.
If you are trying to connect the GR236 to the 2210 to use it as a serial wired mouse rather than bluetooth then you will need the CA-230PS2 cable and ...

Hello there Hershey1986,

The GR-231 is usually very stable, it will only present you with a lag if you are travelling under arduous conditions or if your driving REALLY quickly. In the main, SD car ...

Hello HoudiniQ,

If we try to put GPS Viewer to one side for the moment the settings you need in TomTom are as follows:

NMEA 0183v2 4800 & Bluetooth Serial Port COM8 or 5

These can be acce ...

Hello there Wibby,

The GR-231 is usually a very stable receiver and I would expect an inital lock in your circumstances whilst stationary of around 40s or less.

If your receiver continues to di ...

Hello everyone,

Thankyou for bringing this matter to our attention.......we are currently trying to replicate the problem here, however looking around it would seem that HP are developing a ROM upd ...

Hi there,

Glad things seem to be working for you, I was going to suggest upgrading your software, so hopefully that should solve your problem.

Kindest Regards

Steve
Holux UK Technical Suppor ...

Hello there,

Could I just ask what version of Tom Tom you are running and what SD card are you using?

Holux UK Technical Support

I would second Dave's point on this.......

Looking at the scrolling data again it looks at though the GM-270 is trying to continually re-boot, hence you wont attain a signal lock. If your GM-270 is ...

	PocketGPS
	Web