mio 168 sat settings for tom tom 3

thundergod · Occasional Visitor Joined: May 02, 2006 Posts: 1

I have an old mio 168 and the battery ran out so had to reload everything but need to reset the unit to pick up sats again. can anyone throw some light on what i need to set it to?

aj2052 · Posted: Tue Jun 03, 2008 1:38 am Post subject:

Setting is:
Other NMEA GPS reciever
baud = 4800
Serial cable on on sp2
Dont forget to stand outside after first setting up to get a signal, first fire up can take a while on the mio, it also takes a while if you travel before getting a lock.
_________________
Moto G5s Plus, Sygic 17.4.8

aj2052 · Posted: Tue Jun 03, 2008 1:42 am Post subject:

A tip with the mio if you make the ttn cab file read only, when the battery runs out and you lose tomtom prog, just load file explorer within the mio and double click on ttn cab fille it will reload itself.
_________________
Moto G5s Plus, Sygic 17.4.8

aj2052 · Posted: Tue Jun 03, 2008 1:50 am Post subject:

Just realised your heading says ttn3, the above setting is for ttn6 and possibly 5, if i remember tt3 had different drivers so may not work, I would imagine ttn3 is so far out of date to be useless.
_________________
Moto G5s Plus, Sygic 17.4.8

Border_Collie · Posted: Tue Jun 03, 2008 1:46 pm Post subject:

Thinking back to when I had TT3, I seem to remember using connection TomTom rather than Other NMEA and it worked OK. It was on TT5 that Othere NMEA had to be used.
_________________
Formerly known as Lost_Property
And NO that's NOT me in the Avatar.

	PocketGPS
	Web