Removing Cyclops cams off 760

maca2 · Frequent Visitor Joined: Jul 10, 2005 Posts: 303

Hi
Have just downloaded the speed cams from here, after paying the fee, so now have them on my Garmin 760's SD card.

How can I remove all the Cyclops camera data from the main unit ?.

Can I stop the annoying beeping you get when a camera is detected but I am driving over the speed limit, like doing 34mph in a 30 zone & please don't tell me just to slow down Smile

.

Thanks in advance.

PaulB2005 · Posted: Mon May 19, 2008 11:31 am Post subject:

maca2 · Frequent Visitor Joined: Jul 10, 2005 Posts: 303

So will this just take the sound alert off only when I am over speed limt ?.

I do want a sound alert just to say the camera is comming up it's just the sound when I'm over limt, it just keeps sounding until I reduce speed.

PaulB2005 · Posted: Mon May 19, 2008 2:35 pm Post subject:

If you use Ash10s Camera Manager you can change the alerts for Approach and Overspeed. Just set Overspeed to 0 and you should only get the approach alert.

maca2 · Frequent Visitor Joined: Jul 10, 2005 Posts: 303

OK now have the ash 10's camera manager up & running but only have UK cams.

How do you get it to download both UK & French cams ?.

Nice bit of software isn't it.

PaulB2005 · Posted: Mon May 19, 2008 4:17 pm Post subject:

maca2 · Frequent Visitor Joined: Jul 10, 2005 Posts: 303

That's a shame but then again I am only going over to france for a few days so will just load the normal french cams when I go.

I have followed your instructions & put 0 in the overspeed bit so will test tomorrow.

Thanks for the help & for pointing me to that brilliant software.

	PocketGPS
	Web