no gps device useing ttn5 on micromaxx mdppc150

[thorleykid]

hello everyone, i have a problem putting ttn5 on my micromaxx mdppc150, i can install it and i have put in the update as suggested by yourselves for gps reciever firmware update, but, tomtom cant find a gps devise, any suggestions please

[dabut]

go into configure gps
other nmea
4800 baud rate
serial port sp2
you should then see the little black/yellow circle spinning in top r/h corner then just wait until it locks onto sats pref outside of house
_________________
ipaq 4150 on powered cradle with tt6
medion md95000 with tt6
advent gp400 with tomtom6

[world-traveller]

On my MDPPC200 it needs:

"Other NMEA GPS"
"GPS baud rate 4800"
"Serial Cable on COM1"

The PDA should now display satellite positions and a bar graph display of each received satellite. I find that having too many points of interest enabled really slows the unit down to the point of nothing much working, including the GPS. It cannot cope with 40 POI sets enabled!

We see you’re using an ad-blocker. We’re fine with that and won’t stop you visiting the site.
Have you considered making a donation towards website running costs?.
Or you could disable your ad-blocker for this site. We think you’ll find our adverts are not overbearing!