Im stupid I know but help please

[Macs]

As a new owner of a Navman510 I have already come up against a problem that most of you will laugh ta.
Yesterday I had to go on a journey so I used my favourites and entered my home address as start point, then I entered postcode and address of where I was going then once agin entered my home address on the same trip for the return journey.
No problems at all getting to my forst destination but when I tried to use my Navman to return home it wouldnt plot the route home just kept telling me to Uturn back to my original destination.
What am I doing wrong please?
Do I just enter the first destination then when I get there create a new trip
Do I need to enter my home favourits as start point or will it automatically plot the route from where I am.
How do I plot a return journey?

Thanks for putting up with this problem

[Tim Buxton]

When you arrived at your first destination, did you actually drive past the 'flag'? If not, the software will keep routing you to that point until you do, unless you tell it to 'skip' that point. To do this, go into the Trip Planner Menu, highlight the errant stopover and tap 'Clear'.

I now put my stopovers slightly short, to ensure I actually pass them.
_________________
Tim

[Macs]

Thanks a lot for replying I will try that next time.
Tell me do I need to put home in as the final destination as well?

[Tim Buxton]

[Macs]

, ok thanks

We see you’re using an ad-blocker. We’re fine with that and won’t stop you visiting the site.
Have you considered making a donation towards website running costs?.
Or you could disable your ad-blocker for this site. We think you’ll find our adverts are not overbearing!