Map switching and monitoring with Checkpoint

[s3dbw]

As I regular use TomTom Navigator 3 and checkpoint across Europe, I have a number of European Maps installed. However I have organised the maps such that the relevant POI's for each country, eg speedcams are stored in the particular map for that country.

In this configuration Checkpoint will only see the POI's of the particular map that you use when it first starts, if you switch maps with the system on, when changing countries, it does not appear to automatically pick up the new POI's for that country, you need to shut the system down and restart on the relevant map.

Short of installing all the POI's for each country in every map, is there a way to get checkpoint to switch between maps without having to restart each time?

regards

[s3dbw]

OK, done some experimenting.

After a hard reset and re-install, checkpoint was happy to switch maps each time TomTom changed, however after removing TomTom and re-installing it, Checkpoint for some reason then fails to switch the POI's that it is monitoring when TomTom changes maps?

Can anyone explain whats going on here, as I really dont want to do another hard reset and re-install everything again

Thanks

We see you’re using an ad-blocker. We’re fine with that and won’t stop you visiting the site.
Have you considered making a donation towards website running costs?.
Or you could disable your ad-blocker for this site. We think you’ll find our adverts are not overbearing!